A Gatewood company - serving North Las Vegas, NV
Gatewood Fence & Gate North Las Vegas gate repair team

Electric Gate Repair Cost in North Las Vegas - Honest Price Ranges, Free Written Quote

Real local price ranges for the work, then a free site survey and a written quote for your driveway. Groundworks, power runs and safety gear priced in, not added later.

✓ Licensed & Insured ✓ Written quotes ✓ Permits handled
Schedule Free Estimate

Call to schedule your free estimate

Work is performed by our local vetted partner.

🛡 Licensed & Insured 📝 Written Fixed-Price Quotes 💲 No Change Orders · Free Estimates
Wood & steel frameWood & steel frame
Wrought ironWrought iron
Farm & ranchFarm & ranch
Sliding driveway gatesSliding driveway gates
LiftMaster operatorsLiftMaster operators
Every visit starts with

Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted

The assessment is free and the quote is the invoice.

Get your free estimate
Explore

Styles & brands we work with

  • Wrought iron
  • Wood & steel frame
  • Farm & ranch
  • Sliding driveway gates
  • LiftMaster operators
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Electric Gate Repair Cost in North Las Vegas, NV: What You’ll Actually Pay

Electric gate repair in North Las Vegas usually runs $180 to $650, depending on what failed. A sensor or wiring fix sits at the low end; a control board lands in the middle; a full operator replacement pushes toward the top. The catch is that a dead gate here in July is rarely one problem. It’s the board, the sensor, or the motor, and those are three different invoices. Call (844) 761-9351 and we’ll tell you which one before anyone touches a part.

We’re Gatewood Fence & Gate North Las Vegas, locally owned and owner-operated since 2001, and we’ve watched this exact failure pattern play out across the valley for a long time. When a gate goes electric-dead in July, the honest first question isn’t the price. It’s what the heat took out.

Why a North Las Vegas Gate Fails Differently Than Anywhere Milder

Here’s what we see when we open a control enclosure in August. The board is baked. The sensor lens is fogged with fine dust. The motor might be fine, might not, but you won’t know until the circuit is tested. The summer sun hits a lot of these control boxes dead-on through the afternoon, and the component that tolerates heat least always gives out first. That’s usually the board, not the motor.

Then there’s the dust. The dry, windblown desert grit and the occasional monsoon haboob push fine particulate straight into sensor housings and control enclosures. A gate that quits after a storm often has a dust-contamination story, not a mechanical one. Cleaning and resealing the enclosure is a real repair in North Las Vegas, not a band-aid, because it stops the same failure from coming back next season.

The housing stock plays a role too. A lot of homes in Aliante, Eldorado, and the surrounding communities went up with builder-grade steel and vinyl gates installed in the same window. They’re all failing around now, so much of what we do in North Las Vegas is 15-to-20-year-old operator and hinge replacement rather than new installs. In the HOAs, the repair also has to match the community’s uniform style and color, which shapes what’s possible and what it costs.

Map the Cost by What Actually Broke

Pricing only the visible failure – the gate that won’t move – is how people end up calling again inside a year. Here’s how the line items break down so you can calibrate any quote you’ve already received. These are honest ranges for the North Las Vegas market.

Repair type Typical cost range
Sensor replacement (realignment, dust cleaning, reseal) $180 - $320
Wiring repair (shorts, rodent damage, corroded connections) $200 - $450
Control board replacement $280 - $520
Operator / motor replacement $450 - $650 (unit only varies by brand)
Hinge and hardware repair (welded on site) $150 - $400

A gate sags in the hinge post, not in the middle, and that’s where we start. Fix the panel without the post and you’ll fix it twice. If you want the full picture of how we approach a repair from the first look to the final test, that lives on our Gate Repair page. The table above is the money side of it.

How We Diagnose Before We Quote

The difference between a fair price and a parts-swap bill comes down to the diagnostic. We test the electrical circuit before touching a component. That means checking voltage at the board, tracing the sensor loop, and confirming the motor is actually the failure point before anyone recommends replacing it. The repair cost ends up based on what’s genuinely broken, not on what’s easiest to swap.

Because the work happens on site – welding included, so the gate stays in your driveway rather than getting hauled off – you’re not paying for transport or a shop holding your gate for a week. And the person who diagnoses it is the same one who does the work. Show us the gate closing on its own and we’ll show you where it’s failing.

Here’s how a call typically goes:

  1. You call (844) 761-9351, and a live person answers. Not a voicemail, not a queue.
  2. We ask what the gate is doing (or not doing) and book a window.
  3. We arrive, test the circuit, and isolate the actual failure before quoting.
  4. You get an upfront price, in writing, before any part comes out of the box.
  5. We make the repair on site and test it under real conditions.

Every job carries the 90-Day Done Right Promise, stamped in writing. If it’s not done right, one call brings us back.

What the Real Out-of-Pocket Number Looks Like

A quote isn’t the same as the cost. Two things shrink the real number. First, there’s no trip charge anywhere inside the county, so the price you hear is the price for showing up and looking. Second, there’s $40 off any repair over $200. That brings a $320 sensor repair down to $280. A $520 board replacement becomes $480. Seniors and veterans also get a permanent 10% discount that stacks with the standing offer where it applies.

We don’t quote one number on the phone and charge another at the door. Upfront pricing is a core promise, not a footnote. If you’ve been burned by a national outfit that pulled that exact trick, we understand the caution, and a free second opinion on any written estimate is yours for the asking.

Repair or Replace the Whole Unit?

Straight answer: if the gate frame is sound and the electrical failure is isolated, repair almost always wins on cost. A control board or sensor fix at $280 to $520 keeps a gate that’s otherwise in good shape running for years. Replacing a full unit only makes financial sense when the motor and the board and the wiring are all gone at once, or when the frame itself is failing alongside the electronics.

The break-even math is roughly this. If two or more major electrical components fail in the same year and the frame is showing rust at the welds, replacement starts to pencil out. If it’s one isolated failure on a solid frame, you’d be paying a replacement bill for a repair problem. We’ll tell you which one you’re looking at, honestly, even when the honest answer is the cheaper job.

If you want to see how we handle a straightforward hinge or hardware repair on a North Las Vegas gate, that’s covered on our Gate Repair in North Las Vegas page, and our home page covers the full range of what we fix.

A Safety Note Before You Touch It

Almost every electric gate carries live low-voltage control wiring and, on sliding models, a motor with enough torque to cause serious injury in a jam. We don’t recommend opening a control enclosure or testing wiring yourself, and we never will. A trained professional with the right meter and the right sequence does that safely in minutes. This is one of those jobs where the risk isn’t worth the savings.

FAQs

What Our Customers Say

★★★★★ 5.0 from 7+ reviews

"Fitted a keypad and an intercom so my mother can let carers in without coming down the drive. He set it up and then made her practise with it until she was comfortable."

- Lucinda Marchbanks

"He builds the gates himself. That is not something you can say about the outfits that just order a panel in."

- Doreen Whitfield

"Safety photo eyes on our old gate had been bypassed by whoever serviced it last, which he was genuinely annoyed about on my behalf. Fitted proper sealed ones and wired them the way they should be."

- Otis Redmond
Need Gate Repair help in North Las Vegas? Licensed & insured · 60-minute response · free estimates
Call (844) 761-9351

Request a Free Estimate

Tell us what's going on in North Las Vegas. We'll get back to you fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch
Local Service Coverage
Call Now - 24/7 Dispatch