Wood & steel frame
Wrought iron
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateTrusted Gate Installation for North Las Vegas Homeowners
A new gate in North Las Vegas usually costs $1,800 to $6,500 depending on width, material, and whether an operator is going in. That range is honest, and the number we quote you is the number you pay. Our technicians have up to 25 years of experience, and because we serve North Las Vegas every day, we know what fails here: gate posts set too shallow in caliche, and hardware that rusts fast in desert wind and blowing dust.
Call (844) 761-9351 and a live person answers. Every installation is measured, written up, and priced before we touch a thing, and the whole job carries our 90-Day Done Right Promise in writing. If it’s not done right, we make it right.
What Our Gate Installation Service Includes
Every gate we install starts with the post. We set it deep and true for the soil you actually have, frame the gate square, hang it so it swings or slides without dragging, and weld on site where the job calls for it. Here’s what each type of gate looks like when we put one in.
Driveway Gate
A driveway gate is the wide gate across your vehicle entry, and it’s the one most North Las Vegas homeowners ask for first, especially on corner lots where the side yard faces the street. You need one when a chain-link gate has rusted out, when you’re adding a wall and want the gate to match, or when you want the driveway closed off and the operator wired with a keypad and safety edges. We measure the clear opening at the ground, confirm the driveway slope, and set posts to carry the gate’s real weight, not just its width.

Pedestrian Gate
A pedestrian gate is your walk-through gate, usually 36 to 48 inches wide, and it’s the one that gets used a dozen times a day. You need a fresh one when a sagging walk gate is scraping the ground, when a wooden gate has swollen and stopped latching, or when you want a matching walk gate beside a new driveway gate. We hang it on a hinge post set for the load, add a self-closing hinge if you want it, and confirm the latch lines up every time without forcing it.

Sliding Gate
A sliding gate rolls along a track beside the opening instead of swinging out, so it saves driveway space and works well where a swing gate would block a sidewalk. You need one when you have a wide opening a swing gate can’t handle, when the driveway is short, or when you want an operator that doesn’t need swing clearance. We set the track level, anchor it so it doesn’t lift in heat, and fit the guides and rollers so the gate rolls true instead of walking off its track.

Swing Gate
A swing gate turns on hinges and swings inward or out, and it’s the classic look for most residential entries. You need one when a post has been hit or pulled, when an old swing gate has dropped and won’t clear the ground, or when you’re opening up a new driveway. We check the hinge post first, because a gate sags in the hinge post, not in the middle. Fix the panel without the post and you’ll fix it twice.
Double Gate
A double gate is two leaves meeting in the middle, used for wide driveways and for RV or trailer access. You need one when a single gate is too wide to swing comfortably, or when you want one leaf to open for the car and both to open for a trailer. We frame both leaves so they meet square at the center, set a drop rod or center latch, and make sure the pair lines up with no daylight gap at the seam.
Security Gate
A security gate is a tall, close-set gate at a driveway or walk entry, often paired with access control. You need one when you want the yard closed to foot traffic, when you’re adding a keypad or intercom, or when you want the entry to match a security fence. We build it to close tight, fit it with the operator and access hardware you choose, and test the safety edges before we call it done.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Brands We Service for Gate Installation
We’re certified to service nine major gate brands, and the operator on your new gate is often the brand you already know. LiftMaster operators are common on residential driveways, and we know where their boards and limits wear in our heat. FAAC equipment shows up on heavier swing and sliding gates, and its setup rewards getting the geometry right before the motor ever runs. BFT operators have their own quirks in the travel limits and slows, and we set them the way the manual intends rather than guessing.
Linear and Mighty Mule are the other names we see most, and each has its own habits. Linear is straightforward once the arm geometry is correct, and Mighty Mule is a fine value operator as long as the gate swings free before the motor is asked to move it. We also service Viking, Ghost Controls, DoorKing, and Elite. Whether you have a LiftMaster, an FAAC, a BFT, a Linear, or any other make, we can help you sort out what’s on your gate and price the install around it.
Signs You Need Gate Installation Right Now
- The hinge post is rusted through or leaning. If the post moves when you push the gate, the gate is already failing, no matter how good the panel looks. That’s a rebuild, not a repair, and replacing the gate is usually the right call.
- The gate drags the ground and won’t latch. A gate that catches the concrete is telling you the post has settled or the frame has twisted. It’s a real security risk when it won’t close, and it gets worse with every windy day in North Las Vegas.
- You’re opening up a new driveway or side yard. New concrete, new fence lines, and new gates all need posts set before the finish work. Getting the measurement right at the start saves you a rebuild later.
- The old gate is a patchwork of fixes. When you’ve welded the same corner twice and replaced the same hinge three times, the gate is done. A new one is cheaper over the next few years than another round of repairs.
- You want access control or an operator added. An operator needs a gate that’s structurally sound and a post that can carry the load. If the old gate is tired, installing the motor on it is money down the drain.
Our Gate Installation Process – Step by Step
- 1
Measure and walk the site. We measure the clear opening at the ground, check the driveway slope, and look at the soil and where the underground lines run. A laser level and a string line tell us exactly how square the opening really is.
- 2
Quote it in writing before any work. You get the price in writing, the material, the hardware, and the operator model if there is one. The quote is agreed before we start, so the invoice matches the page you signed.
- 3
Set the posts and frame the gate. We dig and set the hinge and latch posts for your soil, allow the concrete to cure, then frame the gate square and hang it so it swings or slides free by hand. On-site welding means the gate stays in your driveway through the job.
- 4
Fit the hardware and operator. Hinges, latches, rollers, drop rods, and stops go on and get adjusted. If there’s an operator, we set its travel limits, slows, keypad, and safety edges, and we test them with the gate moving.
- 5
Final test and the promise. We run the gate open and closed a dozen times, check the latch lines up, and hand you the job with the 90-Day Done Right Promise stamped in writing. One call brings us back if anything’s off.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Installation Cost in North Las Vegas?
A typical pedestrian gate in North Las Vegas runs $1,200 to $2,600 installed, a standard driveway gate runs $2,500 to $5,500, and a wide double gate or a sliding gate with an operator can reach $7,000 and up. Those ranges reflect what we actually see here, not a national average.
What moves the price: the width and height of the gate, the material (steel, aluminum, wrought iron, or cedar), and the operator. FAAC and BFT operators cost more than a Linear or a Mighty Mule, and where a keypad, intercom, or access control goes in, that’s a separate part of the job. Soil and slope matter too. Hard caliche and a steep driveway take longer to set posts than flat, worked ground, and we tell you that upfront instead of surprising you at the end.
To avoid overpaying, get the quote in writing with the operator model named, and don’t pay for a motor until you know the gate swings free by hand. Our estimate is free and no-hassle, with a free second opinion on any written estimate you already have. Every price is quoted and agreed before any work starts, so there’s no door-price surprise. Seniors and veterans get a permanent 10% discount, and there’s no trip charge inside the county.
Call (844) 761-9351 for your exact number. The estimate is free, and you’ll talk to a real person.
Gate Installation Near North Las Vegas – Our Service Area
We install gates in North Las Vegas and the nearby communities we know well, including Sunrise Manor, Winchester, Whitney, and the neighborhoods around Las Vegas. If you’re in a neighboring town or out in the county, call and we’ll tell you straight when we can be out. You can see the full scope of what we do on our home page, or look at gate installation in Las Vegas and gate installation in Sunrise Manor if you’re closer to those areas.
Serving North Las Vegas, NV – Our Local Coverage Area
We serve North Las Vegas and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Gate Installation in North Las Vegas
Gate installation is the measured, permanent job of setting new posts, framing and hanging a gate, and fitting the hardware or operator so it opens and closes correctly. It’s different from a repair, which fixes a gate you already have. If the post is sound and the frame is straight, a repair may be all you need, and we’ll tell you so. If the gate is at the end of its life, an install is the right call.
A standard pedestrian gate is usually a single-day job once posts are set, and a driveway gate runs one to two days depending on the operator. Setting posts in our caliche can add time, and concrete needs to cure before the gate hangs. We schedule installation work ahead rather than promising a same-day slot, and we give you a written window. Call (844) 761-9351 and we’ll get you measured and on the calendar.
Most pedestrian gates land between $1,200 and $2,600 installed, and most driveway gates run $2,500 to $5,500, with operator and access control factored separately. Width, material, slope, and soil drive the difference. Your price is quoted in writing and agreed before any work starts. Call (844) 761-9351 for a free estimate and a free second opinion on any written quote.
Yes. We’re certified to service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. That matters on an install because the operator has to match the gate and the way it moves. We set the limits and slows properly and test the safety edges before we leave. Whether your gate will run on a LiftMaster or a Mighty Mule, we can help you choose and install it.
We answer the phone 24/7, and a live person picks up, not a voicemail or a queue. Installation itself is scheduled work, since gates get measured and ordered, but if a gate has failed and left your property open, call and we’ll talk through the fastest safe option. For urgent problems on an existing gate, see our gate repair in North Las Vegas page. Call (844) 761-9351 any hour.
Every installation carries the 90-Day Done Right Promise, stamped in writing on the job. If something isn’t right within that window, one call brings us back to make it right, with no runaround. The promise is stated plainly, not hedged. Ask for it in writing on the estimate, and we’ll hand it to you.
Clear the driveway and the gate area the morning of the job, and move vehicles so we have a clean work zone. Tell us about underground lines, sprinkler runs, or anything buried near the posts, since we dig where the posts go. If an operator is going in, confirm where the power will come from and who’s running it. Questions before the day? Call (844) 761-9351 and a real person will walk you through it.
Schedule Your Gate Installation Service in North Las Vegas Today
Call (844) 761-9351 for a free, no-obligation estimate on your North Las Vegas gate. A live person answers 24/7, the price is agreed before we start, and every job carries the 90-Day Done Right Promise. Need related work? We also handle gate motor and opener service, gate access control, and gate parts and welding. Call today and let’s get your gate measured.
Written by the team at Gatewood Fence & Gate North Las Vegas.