Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateLinear Keypad & Intercom Repair: The North Las Vegas Owner’s Guide
A Linear keypad or intercom repair in North Las Vegas typically runs $185 to $420 installed, depending on whether we’re replacing just the keypad, the intercom module, or the wiring feeding either one. We can often get eyes on it the same day you call. Most owners don’t find out the keypad is failing until the gate quits answering and they’re standing in the driveway punching a code that used to work. The intercom side usually goes quieter and slower: crackle before the button works, a chime that fires late, a guest who can hear you but you can’t hear them.
Which Linear Models This Applies To
Linear’s keypad and intercom line splits into a few families, and knowing yours matters before we order anything. The AK-11, AK-12, and newer AK-21 keypads are the post-mounted, hardwired units most North Las Vegas driveway gates get. If you have a telephone-style entry system, you’re likely on the RE-1, RE-2, or the AM/RE series intercom. The older Linear AE-500 and AE-1000 access controllers pair with dedicated keypads and won’t accept every newer pad – that’s the compatibility gotcha that gets people. You can spot your model on a stamped plate inside the keypad housing, or on the back of the intercom panel once it’s off the stanchion. Measure the plate footprint and the post spacing before you buy anything. On the OEM-versus-aftermarket call: Linear-branded keypads carry the right connector and the correct code memory for their controller, and a generic 12-volt pad won’t talk to an AE-series board even if it fits the opening. For North Las Vegas sun exposure, stick with factory or factory-equivalent.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Signs Your Linear Keypad & Intercom Repair Is Failing
- Codes quit working after a power flicker. The keypad lost its memory or the controller’s lockout tripped. North Las Vegas summer brownouts knock these loose regularly.
- Keypad buttons feel mushy or need a hard press. UV breakdown of the membrane. It’s a slow death, not sudden, and 6 to 9 years is what we see in the desert climate.
- Intercom crackles before the visitor speaks. Moisture got into the speaker grille or the wiring connector behind the panel corroded. Common on gates near irrigation runoff.
- One-way audio on the intercom. The mic or speaker leg of the pair has failed, or a wire is nicked between the house station and the gate.
- Backlight out but codes still work. Just the LED driver. Cosmetic, but it tells us the board is aging and the keypad is near end of life.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what North Las Vegas owners actually pay us, parts and labor together, quoted and agreed before we touch a screwdriver:
- Keypad-only replacement, standard post-mount: $185 to $275
- Intercom station replacement, existing wiring good: $240 to $360
- Intercom replacement plus new wire run: $320 to $420
- Keypad and controller board together: $380 to $540
The range is driven by wire condition (old direct-burial cable in the desert bakes hard and needs replacing), whether the post housing is reusable, and how far the run is from the house. Every job carries the 90-Day Done Right Promise in writing. And yes, the price we quote on the phone is the price you pay unless we find something we can’t see from the curb – and then we call you before we spend a dollar more.
DIY or Call Us?
You can safely check the obvious: trip the breaker to the gate controller, reseat the low-voltage plug on the back of the keypad, and confirm the intercom station wiring at the house hasn’t been unplugged by a vacuum. Anything past that – pulling the keypad off the post, chasing 12-volt wiring, entering programming mode on a Linear controller – that’s where DIY goes sideways, because a wrong code in the AE-series controller can lock the whole gate down. Low voltage still bites, and direct-burial wiring in North Las Vegas often sits in conduit full of sand and water. We install Linear-compatible keypads and intercoms, and we also service LiftMaster, Mighty Mule, and Ghost Controls for owners who’ve got a mixed setup. Gatewood Fence & Gate is an independent service provider and is not affiliated with Linear. Call (844) 761-9351 and a live person picks up, 24/7.
FAQs
Expect 6 to 9 years for a UV-exposed exterior keypad and 8 to 12 years for an intercom panel with good wire behind it. The desert sun is the equalizer – it degrades membranes and speaker cones faster than most of the country, and the heat cycling inside the housing cracks solder joints over time.
Sometimes, yes. A corroded connector, a chime module, or a nicked wire can often be fixed for $95 to $140 without a new part. But if the membrane or the controller memory is gone, replacement is the honest answer – we’ll tell you which one you’re looking at.
A keypad-only swap is usually 45 minutes to an hour. An intercom replacement with an existing wire run takes 1 to 2 hours. If we’re running new wire, plan 2 to 4 hours depending on the trench path and distance.
We order factory Linear or factory-equivalent parts matched to your exact model number, and we confirm the model before ordering – no guesses, no “will-fit” boards that brick a controller. In North Las Vegas, that sourcing usually means the part is on hand within a day or two of your call.
Written by the team at Gatewood Fence & Gate North Las Vegas, serving North Las Vegas and nearby areas.