Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateElite Gate Motor & Opener in North Las Vegas: What to Know First
We repair, replace, and install Elite gate motors and openers for North Las Vegas homeowners, and most diagnostic visits turn into same-day repairs once we’re on site. Typical fixes – a dead control board, a slipping limit switch, a battery that won’t hold a charge – run $220 to $560, and replacements or new installs are quoted after we measure your gate, not over the phone. We’re an independent Elite service provider, meaning we work on Elite equipment but we’re not Elite and aren’t authorized by them. The price you hear from us the first time is the price on the invoice. If you own an Elite gate system in North Las Vegas and it’s acting up, call Gatewood Fence & Gate North Las Vegas at (844) 761-9351 and a live person will pick up.
How Elite Products Fail – and How We Fix Them
Elite systems show up on a lot of residential slides and swings in the older neighborhoods around North Las Vegas, and they fail in fairly predictable ways. Here’s what we actually see when we open the control box.
- Control board corrosion in the SL-series slide operators. The SL150 and SL200 line puts the board low in the housing, and our summer dust storms push fine grit right up into that cavity. Once grit collects on the board, the contacts arc and the operator starts stuttering mid-travel. We clean and reseat the board, apply dielectric grease at the terminals, and reposition the housing seal so dust can’t route the same way twice.
- Limit switch drift on swing operators. If your gate stops short of full close or reverses before it hits the post, that’s usually a limit switch that’s slipped out of adjustment, not a dead motor. On Elite swing arms this shows up most in the summer heat, when the arm housing expands and the cam shifts a fraction. We reset the limits against a measured open and close angle, then re-torque the arm bracket so it holds.
- Battery backup that won’t hold a charge. Elite’s battery backup boards are particular about battery voltage; a two-year-old battery will test fine at rest and fail the moment the gate moves. We load-test the battery under real gate weight, which catches the ones a static meter misses, and we stock the right replacement size rather than whatever fits.
- Gearbox wear on heavier slide gates. A slide gate that groans and then starts dragging mid-travel usually means the gearbox is losing teeth. Repair-first means we check whether the gear set is serviceable before we discuss a new operator, and on Elite slide motors it often is.
- Intercom and keypad integration dropouts. When the keypad works but the intercom doesn’t (or vice versa), the problem is almost always a shared low-voltage line with a bad splice, not the Elite board. We trace the line with a meter, find the splice, and redo it properly with weatherproof connectors.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Elite Gate Motor & Opener Process
- 1
The call. A live person answers, we ask what the gate is doing, and we book a window. Inside the county there’s no trip charge.
- 2
Diagnostics on site. We test the operator under load, check the limits, the battery, the control board, and the low-voltage wiring. We show you what we find before we quote anything.
- 3
The parts decision. If the Elite board or gearbox needs replacing, we explain the OEM-versus-aftermarket difference in plain terms, including what it does to any remaining Elite warranty, and you decide.
- 4
The repair. We do the work in your driveway – on-site welding and repair, not hauling the gate off. Most repairs finish in one visit.
- 5
The test. We run the gate through full open and close cycles, test the safety edges and reverse function, and make you operate it yourself before we pack up.
- 6
The guarantee. Every job carries the 90-Day Done Right Promise in writing. If it’s not right, one call brings us back.
See the difference
Before
After
Before
After
Before
AfterWhat Elite Gate Motor & Opener Costs in North Las Vegas
Here’s what Elite gate motor and opener work typically runs in North Las Vegas. These are ranges we see on real jobs, not a sales script.
- Diagnostic visit (inside county): free – no trip charge.
- Limit switch adjustment or reset: $115 – $180.
- Battery backup replacement (load-tested, correct size): $140 – $240.
- Control board repair or reseat: $180 – $340.
- Full board replacement: $280 – $560.
- Motor or operator replacement (Elite slide or swing): $750 – $1,600, depending on gate weight and travel length.
- New Elite operator installation: quoted after measure – gate weight, gate type, and power location all move the number.
What moves the price: gate weight, the length of travel, whether the power run is already in place, and whether we’re repairing an existing Elite operator or installing new. The number we quote is the number you pay. Call (844) 761-9351 for a free estimate.
Why North Las Vegas Homeowners Call Gatewood Fence & Gate North Las Vegas for Elite Work
We’ve been locally owned and owner-operated since 2001, and our technicians have up to 25 years of experience working on Elite and the eight other major gate brands we service – LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, and Mighty Mule included. When we quote an Elite job, we quote it once. The 90-Day Done Right Promise is stamped in writing on every job, and if we got it wrong, one call brings us back. Our technicians are background-checked and uniformed. We don’t haggle and we don’t upsell – the standing offers are simple: $40 off any repair over $200, no trip charge inside the county, a free second opinion on any written estimate, and a permanent 10% discount for seniors and veterans. A live person answers every call, 24 hours a day.
FAQs
Will repairing my Elite gate motor void the Elite warranty?
Not if the work is done correctly with the right parts. Elite’s warranty terms cover defects in their equipment, and on repairs we’re careful to use OEM parts where warranty status matters so you don’t lose coverage you already have. We’ll tell you upfront if a fix puts that at risk before we touch anything. Call (844) 761-9351 for a free estimate.
Can you get Elite parts in North Las Vegas?
Yes – Elite control boards, gearboxes, batteries, and limit components are all available to us through parts channels. Most common parts are in hand for same-day repair; less common ones add a day or two to the timeline. We’ll give you the real lead time before you commit.
Should I repair or replace my Elite gate operator?
Repair first, most of the time. Elite operators are built to be serviced, and boards, gear sets, and batteries are all replaceable. We only recommend replacement when the motor or gearbox is beyond economic repair, or the gate itself has changed and the operator is now undersized. We’ll show you the numbers both ways on a written estimate.
How fast can you get to my Elite gate in North Las Vegas?
Inside the county there’s no trip charge and we schedule a real window – not a four-hour maybe. Most diagnostic visits happen same-day or next-day, and when we’re on site, most repairs finish in one trip. The number is (844) 761-9351.
Do you service Elite intercom and keypad integration?
Yes – intercom, keypad, and access control integration on Elite systems is part of what we do. Most dropouts trace back to a bad splice on the low-voltage line rather than the Elite board itself, and we can find and fix it in a single visit.
Written by the team at Gatewood Fence & Gate North Las Vegas, serving North Las Vegas and nearby areas.