Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateMighty Mule Gate Installation in North Las Vegas: What to Know First
We install Mighty Mule gate openers and gates for North Las Vegas homeowners, and most single-swing driveway jobs are measured, ordered, and scheduled within a few days to a couple of weeks depending on what the gate needs. You get a written price before we order a thing, and that’s the number you pay. A basic Mighty Mule swing opener on an existing gate often lands in the $1,600 to $3,400 range installed, with dual gates and solar setups running higher.
This page is for North Las Vegas homeowners who already own a Mighty Mule opener, or who are set on one, and want it put in correctly by someone who works on them all the time. We’re an independent Mighty Mule service provider: not affiliated with or authorized by the manufacturer, just very good at their equipment. Call (844) 761-9351 and a live person picks up.
How Mighty Mule Products Fail – and How We Fix Them
Mighty Mule builds a solid DIY-grade opener, but this desert climate and the clay-heavy soil in parts of North Las Vegas are hard on them. Here’s what we actually see when we pull into a driveway:
- Control board cooked by our summer heat. The Mighty Mule 350 and 500 series run their control boards hard in an unshaded box, and July afternoons near 115°F cook them. The symptom is an opener that works fine at 6 a.m. and refuses to move by 2 p.m. We diagnose the board, not just the motor, and tell you honestly whether it’s worth replacing on a unit that old.
- Battery and solar sag. The Mighty Mule FM700 and solar MM series lean on a battery that loses capacity in the heat. Owners get used to a slow gate and assume the opener is dying. Often it’s a tired battery and a panel that isn’t getting real sun. We test the whole power path before quoting anything.
- Post lean from our shrink-swell soil. A gate sags in the hinge post, not in the middle, and that’s where we start. North Las Vegas soil moves with the wet season and dry season, and a post set shallow will lean just enough to bind the opener arm. Sometimes the install is fine and the post needs resetting first, which is a welding and concrete job, not an opener job.
- Undersized posts on heavier gates. When a homeowner hangs a heavier new gate on a Mighty Mule arm built for a lighter panel, the arm over-travels and wears its gears. We size the opener to the actual gate weight and width before we install, so the equipment lasts.
- Misaligned limit switches and arms. Mighty Mule single and dual swing arms need their limits set precisely or the gate stops short or grinds at the end of travel. It’s a small adjustment that lots of installers skip, and it’s the difference between a smooth gate and a noisy one.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Mighty Mule Gate Installation Process
Every Mighty Mule job follows the same steps, whether it’s a driveway swing gate, a pedestrian gate, or a sliding gate:
- 1
Free measure and walk-through. We look at the gate, the posts, the power run, and where the sun hits the opener. If a repair will get you there cheaper than replacement, we say so.
- 2
Written price before we order. You get the number in writing, including the opener, hardware, and any post or welding work. That’s the price.
- 3
Parts decision, made in the open. Sometimes OEM is the right call for a warranty-safe fix; sometimes a quality aftermarket arm is the smarter buy. We tell you which and why, not just what’s in stock.
- 4
Install and weld on site if needed. If the posts or gate frame need work, we weld in your driveway rather than hauling the gate off. The gate stays where it lives.
- 5
Test in both directions, then clean up. We cycle the gate, set the limits, check the safety edges and photo eyes, and walk you through it. Every job carries our 90-Day Done Right Promise in writing.
See the difference
Before
After
Before
After
Before
AfterWhat Mighty Mule Gate Installation Costs in North Las Vegas
Here are honest ranges for the Mighty Mule work we do in North Las Vegas. Your actual price depends on the gate, the power situation, and whether the posts need work, but this gets you close:
| Job | Typical installed range |
|---|---|
| Mighty Mule swing opener on existing gate | $1,600 – $3,400 |
| Dual-swing gate, two Mighty Mule arms | $2,800 – $5,200 |
| Sliding gate with Mighty Mule operator | $2,400 – $4,800 |
| Solar setup with battery and panel | add $400 – $900 |
| Post reset or on-site welding | $250 – $700 |
| New gate plus Mighty Mule opener | $3,200 – $7,500 |
What moves the price: gate weight and width, whether you have power at the gate or need a run, solar versus wired, and post condition. We don’t guess on the phone and surprise you at the door. The price is quoted and agreed before any work starts. Call (844) 761-9351 for a free estimate.
Why North Las Vegas Homeowners Call Gatewood Fence & Gate North Las Vegas for Mighty Mule Work
We’re locally owned and owner-operated, and our technicians have up to 25 years of experience. We’re certified to service nine major gate brands, including Mighty Mule, so if your opener turns out to be a LiftMaster, Ghost Controls, or DoorKing unit instead, we’re not stuck. That matters when your neighbor’s gate uses different equipment than yours.
Every job carries the 90-Day Done Right Promise in writing: if it’s not done right, we make it right, one call and we’re back. We fix what’s fixable and weld on site rather than swapping parts that don’t need it. We’re independent from Mighty Mule and every other manufacturer, which means our advice is about your gate, not a sales quota. Standing offers include $40 off any repair over $200, no trip charge inside the county, a free second opinion on any written estimate, and a permanent 10% discount for seniors and veterans. A live person answers every call, 24 hours a day.
FAQs
Installation by an independent provider doesn’t automatically void a Mighty Mule warranty, but the manufacturer’s terms are theirs to set, so read your paperwork. We install to spec, keep the parts we use documented, and never cut corners that put a warranty at risk. Call (844) 761-9351 and we’ll walk you through it.
Yes, we source Mighty Mule arms, boards, batteries, and controls, and tell you upfront whether OEM or a quality aftermarket part is the better call for your gate. Parts lead time depends on the model. Call (844) 761-9351 for a free estimate.
Often repair wins, especially when the opener is sound and it’s the board, battery, or a post that’s the real problem. We diagnose before we recommend anything, and if a repair gets you another several years, that’s what we’ll tell you. Call (844) 761-9351 for an honest answer.
Installation is measured, ordered, and scheduled, so plan on a few days to a couple of weeks depending on the model and any gate or post work. We give you a real date, not a maybe. Call (844) 761-9351 to get on the schedule.
Yes, our heat and soil are genuinely hard on openers. Shade the control box where you can, keep the battery fresh, and check post stability each spring. We’ll advise on the specifics during your estimate.
If your Mighty Mule needs installation done right, call (844) 761-9351 for a free estimate. A live person answers, we quote before any work starts, and the name is on the shop and on every invoice.
Written by the team at Gatewood Fence & Gate North Las Vegas, serving North Las Vegas and nearby areas.