A Gatewood company - serving North Las Vegas, NV

Mighty Mule Gate Motor & Opener in North Las Vegas, NV

Wrought ironWrought iron
Wood & steel frameWood & steel frame
Farm & ranchFarm & ranch
Sliding driveway gatesSliding driveway gates
LiftMaster operatorsLiftMaster operators
Every visit starts with

Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted

The assessment is free and the quote is the invoice.

Get your free estimate

Mighty Mule Gate Motor & Opener in North Las Vegas: What to Know First

We repair, replace, and install Mighty Mule gate motors and openers across North Las Vegas as an independent Mighty Mule service provider – most repair jobs are wrapped up in a single visit, and a straight motor swap is often done the same day once we’ve confirmed the parts on hand. Prices are quoted upfront and agreed before we touch a single bolt, so the number you hear is the number you pay.

Call (844) 761-9351

If your Mighty Mule arm is grinding, your gate has started stopping halfway, or the opener quit after a power blip, this page is for you. Driveway gates in North Las Vegas take a beating – blowing sand, brutal summer heat, and monsoon dust all work on a motor differently than they do in milder parts of the country. You can call us at (844) 761-9351 and a live person picks up.

How Mighty Mule Products Fail – and How We Fix Them

Mighty Mule is the brand we see most often on DIY-installed residential gates around North Las Vegas, and the failures tend to fall into a handful of predictable patterns. Here is what actually goes wrong, model by model.

  • MM360 and MM560 control boards fried by heat and sun. These single-arm swing openers are the most common Mighty Mule units we see on older North Las Vegas properties. The control board sits in a housing that bakes in direct afternoon sun, and after several summers the board stops accepting limit settings or the gate drifts past its open stop. The real culprit is usually heat cycling on the board and a limit switch that has gone intermittent – not the motor itself. We test the board and switch separately so you don’t pay for a motor you don’t need.
  • MM260 and MM272 arms that stall midway. On these lighter swing models, a gate that stops halfway is almost always a battery or charge problem, not the arm. These openers run off a 12V battery that’s kept topped up by a small solar panel or trickle charger, and in North Las Vegas the panel gets coated with dust and the battery ages out faster than owners expect. We load-test the battery, clean and check the charge circuit, and tell you honestly whether you need a battery, a panel, or both.
  • Solar-charged units that “work fine” then quit in summer. The desert heat kills lead-acid batteries early, and dusty solar panels cut charging. A unit that ran all winter can die in July. We check charge output and battery health before recommending a replacement, and we’ll point you to a quality aftermarket battery when the OEM one is priced like gold for the same chemistry.
  • Slide and rack-and-pinion motors with stripped gears. Mighty Mule slide operators on rolling gates around North Las Vegas wear the drive gear when a gate gets heavy or the track fills with grit. Grinding or a gate that lurches is your warning. We clear the track, inspect the gear, and repair what’s worn rather than selling you a whole new operator.
  • Mighty Mule remotes, keypads, and intercom integration that stop responding. Often it’s a pairing or receiver issue, not a dead unit. When a homeowner wants the Mighty Mule opener tied into an intercom or a newer keypad, we handle the wiring and pairing so the gate answers the house, not the other way around.

One thing worth knowing that you won’t find on Mighty Mule’s own site: on the MM360/MM560 boards, a failing limit switch can mimic a dead control board, and a lot of shops replace the whole board when a $20 switch was the real problem. We test before we swap. That’s the difference between a repair and a replacement.

Explore

Styles & brands we work with

  • Wrought iron
  • Wood & steel frame
  • Farm & ranch
  • Sliding driveway gates
  • LiftMaster operators

Our Mighty Mule Gate Motor & Opener Process

Every Mighty Mule job follows the same sequence, whether it’s a battery that won’t hold or a full motor install. The gate stays in your driveway – we weld and repair on site.

  1. 1
    Diagnose before we quote. We test the arm, the control board, the battery, the limits, and the gate’s own swing or roll. If the gate is binding, the motor isn’t the problem – the hinge or track is. We find the real failure first.
  2. 2
    Parts decision, in plain terms. When an OEM Mighty Mule part is the right call, we say so. When a quality aftermarket battery or gear will do the same job for less without voiding anything that matters, we say that too. You choose, with the trade-offs on the table.
  3. 3
    The repair, done on site. Motor swaps, board replacements, gear repairs, battery and charge-circuit work, remote and keypad pairing, intercom integration. No hauling the gate off.
  4. 4
    Full cycle test. We open and close the gate multiple times, check the limits, the safety edges, and the force settings, and confirm the opener reverses properly before we call it done.
  5. 5
    The guarantee, in writing. Every job carries our 90-Day Done Right Promise – if it’s not done right, we make it right. Stamped on the invoice, not buried in fine print.
  6. 6
    Cleanup and a walk-through. We leave the driveway the way we found it and show you what we did, so you know your Mighty Mule opener and what to watch for next summer.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

What Mighty Mule Gate Motor & Opener Costs in North Las Vegas

Here’s the honest range. Every price is quoted and agreed before work starts – no surprises at the door.

Job Typical range
Diagnostic and repair (battery, limits, board, pairing) $150 – $350
Control board or arm replacement $280 – $550
Battery and charge-circuit service $120 – $260
Full Mighty Mule swing motor replacement $600 – $1,100
Slide motor / gear repair $350 – $750
Intercom or keypad integration $200 – $450

What moves the price: whether the gate itself is binding, how old the wiring is, whether the unit is solar or hardwired, and how accessible the operator is. A gate that needs hinge work before the motor can run right costs more than a straight swap. Call (844) 761-9351 for a free estimate – estimates cost you nothing, and there’s no trip charge inside the county.

Why North Las Vegas Homeowners Call Gatewood Fence & Gate North Las Vegas for Mighty Mule Work

We’re a locally owned, owner-operated gate shop, and Mighty Mule is one of nine major brands we’re certified to service – alongside LiftMaster, Ghost Controls, and DoorKing. Our technicians have up to 25 years of experience, and they know exactly how a Mighty Mule fails in this climate. That’s the point: the failure modes in North Las Vegas are not the same as in a mild coastal town.

What you get with us is a name and a shop you can drive to and look in the eye. A live person answers the phone around the clock – no voicemail, no dispatch queue three states away. Every job carries the 90-Day Done Right Promise in writing. And our standing offers are on the table without haggling: $40 off any repair over $200, a free second opinion on any written estimate, no trip charge inside the county, and a permanent 10% discount for seniors and veterans. We repair what other shops want to replace, and we weld on site so the gate stays where it belongs.

FAQs

Need Gate Repair help nationwide? Licensed & insured · 60-minute response · free estimates
Call (844) 761-9351
Local Service Coverage

Request a Free Estimate in North Las Vegas

Tell us what you need - Gatewood Fence & Gate North Las Vegas responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch