Wood & steel frame
Wrought iron
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Repair Before & After in North Las Vegas, NV
A gate that won’t close right tells you something every single day. The drag, the gap, the motor that grinds and quits. Photos of the fix tell you more than a paragraph of claims ever will, so this is where we show the work: what came in, what we found, and what the gate does now when you pull up the driveway. Here’s what we’ve been putting right around North Las Vegas.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Recent Transformations
The jobs below are typical of what comes through the shop and what we run out on in the neighborhoods around North Las Vegas. Each one is a different kind of failure, which is the point: a sagging gate and a dead operator are not the same problem, and they don’t get the same fix.
Sagging Double Driveway Gate – Hinge Post Repaired and Reset
Before
After
Before
AfterThe problem wasn’t the gate leaf, it was the hinge post – the gate sagged at the post and the far end dragged the concrete every time it swung. We reset the post, welded the hinge brackets back to square, and rehung both leaves so the gap was even across the middle. The result is a gate that swings on one finger and latches on the first try, which is how it should have been from the start.
Automatic Slide Gate – Operator and Safety Edge Restored
Before
After
The gate would start to open and stall halfway, and the homeowner had already noticed it wasn’t backing off when something was in the way. A safety edge that doesn’t reverse is the part of an automatic gate you never want to skip, so we tested the edge first, found the failing contact, then traced the stall to a worn drive component and a track that had shifted. We replaced what had failed, realigned the track, and confirmed the reverse-on-contact worked before we called it done. It now runs the full length without tripping and stops when it should.
Rusted Wrought-Iron Gate – On-Site Welding and Repaint


A cracked weld at the bottom rail had the gate flexing every time it moved, and the rust was working its way along the frame. We welded it in the driveway rather than hauling the gate off – on-site welding keeps the gate on its posts and saves you the wait. We ground the weld smooth, treated the rust, and repainted the repaired section to match. The frame is rigid again and the gate closes true.
Pedestrian Gate – Hinge and Latch Alignment


The walk gate had dropped enough that you had to lift it to close, and the latch no longer lined up with the strike. We adjusted the hinges, squared the leaf, and reset the latch so the gate catches on its own with a light push. Small repair, big difference – a gate you can close with one hand instead of a shoulder.
Gate Motor That Wouldn’t Open – Opener Serviced and Controls Reset


The motor clicked when you pressed the remote but the gate never moved, and the keypad had stopped talking to the opener altogether. We checked the operator, found the fault in the control side, serviced the unit, and re-paired the remotes and keypad so every point of entry worked again. The gate opens from the car, the keypad, and the button inside the house – all three, the way it’s supposed to.
Gate Access Control – Keypad and Entry Reconnected


Residents couldn’t get in – the keypad was rejecting valid codes and the gate wasn’t releasing when it should. We traced it through the access control wiring, repaired the connection, and reprogrammed the entry so codes worked again. The gate releases on command and the entry point is reliable, which matters when it’s the front door to the property.
Want Results Like These?
Every one of these gates went from a daily headache to something that just works. If yours is dragging, stalling, or not latching, call Gatewood Fence & Gate at (844) 761-9351. We’ll come look, quote it upfront before any work starts, and stand behind the repair with the 90-Day Done Right Promise. Call today for a free estimate.
Written by the team at Gatewood Fence & Gate North Las Vegas.
See the difference
Before
After
Before
After
Before
After