Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateDoorKing Gate Installation in North Las Vegas: What to Know First
We install DoorKing gate systems in North Las Vegas as an independent DoorKing service provider, and most residential jobs are measured within a few days and finished in one to two days on site. Expect a written price before anything is ordered or dug: a typical driveway slide gate lands somewhere between $3,400 and $7,800 installed, and a pedestrian gate with a DoorKing operator runs $1,900 to $3,900. The number you agree to is the number on the invoice.
This page is for the homeowner with a DoorKing operator already on the property, or a DoorKing gate they inherited and want set up correctly, from the 6050 slide operator series to the 6400 swing series to the 1520/1530 pedestrian line. If that sounds like your gate, call (844) 761-9351 and a live person will pick up, day or night.
How DoorKing Products Fail – and How We Fix Them
DoorKing builds solid operators. What we find in North Las Vegas is rarely a bad brand. It’s a bad install or a part that met our desert conditions and lost. Here are the five things we run into most, and what we do about each one.
- 6050 slide operators with chain sag and pad wear. The chain on a 6050 stretches faster than owners expect when the gate track isn’t level, and a sagging chain eats the idler sprocket and eventually the pad. Cause is almost always a foundation that settled or a track that was never leveled for our caliche-hard soil. We re-level the track, reset the pad, and tension the chain to spec rather than swapping the whole operator.
- 6400 swing operators binding at the hinge. A 6400 arm fights the gate when the hinge post has crept. The operator gets blamed, but the gate sags in the hinge post, not in the middle, and that’s where we start. We measure the post, weld or reset the hinge as needed, and the arm stops straining. Fix the panel without the post and you’ll fix it twice.
- 1520/1530 pedestrian gates with misaligned strikes. These small operators take a beating when the gate leaf twists or the strike plate drifts. The symptom is a gate that closes then reopens, or buzzes at the latch. It’s almost never the control board. We square the leaf, reset the strike, and re-set the limit switches.
- Undersized power runs and missing low-voltage protection. DoorKing solar and low-voltage setups in North Las Vegas get installed on Romex or undersized wire, then fail when summer heat pushes the draw. We run correct gauge, add surge protection at the operator, and size the transformer to the actual gate, not the box label.
- Loop and safety-edge failures from blown controllers and sun-baked rubber. Our UV load and summer heat cook rubber safety edges and degrade vehicle loops faster than in cooler markets. When a loop fails on a 6050 or 6400 install, we test the detector and loop independently, cap the edge properly, and replace with UV-rated edge material, not whatever’s on the shelf.
If it’s not a DoorKing, we also handle LiftMaster, Mighty Mule, and Ghost Controls, and we’re certified to service nine brands in total. The approach is the same: find the actual cause before we quote.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our DoorKing Gate Installation Process
Here’s what a real DoorKing job looks like from the first call to the moment we pull out of your driveway.
- 1
On-site measure and assessment. We look at the gate, the operator, the power, the soil, and the driveway grade. For a slide gate that means checking the pad and track; for a swing gate, the hinge posts. You get a written scope with the parts and labor spelled out.
- 2
Written price, agreed up front. No surprises at the door. If you’ve got another written estimate, bring it, and we’ll give you a free second opinion on it before you decide.
- 3
Parts decision, OEM vs. quality aftermarket. We’ll tell you when a genuine DoorKing part is worth the wait and when a quality aftermarket equivalent does the job at half the price, and we’ll note what it does to your warranty either way. We don’t swap parts that don’t need swapping.
- 4
Install and on-site welding. Track, posts, arms, and safety devices go in, and the gate stays in your driveway. We weld here, not at a shop in another part of town.
- 5
Full cycle test with safety devices live. We run the gate through full travel with loops, edges, and photo-eyes active, and we show you the stop-and-reverse working before we call it done.
- 6
Walkthrough and the 90-Day Done Right Promise in writing. You get the paperwork stamped with the promise. If something isn’t right inside 90 days, one call brings us back. No runaround.
See the difference
Before
After
Before
After
Before
AfterWhat DoorKing Gate Installation Costs in North Las Vegas
Prices below are typical installed ranges for North Las Vegas, not phone quotes that change at the door. Your written estimate depends on gate width, operator model, power run, and whether the existing pad can be reused.
| Job | Typical installed range |
|---|---|
| Pedestrian gate with DoorKing 1520/1530 | $1,900 – $3,900 |
| Single swing gate with DoorKing 6400 | $2,800 – $5,600 |
| Driveway slide gate with DoorKing 6050 | $3,400 – $7,800 |
| Double gate with two DoorKing operators and sync | $6,500 – $12,500 |
| Safety edges, loops, and photo-eye package | $450 – $1,400 |
| Power run or dedicated circuit | $650 – $2,200 |
What moves the price: gate width and weight, whether the pad needs replacing, how far the power has to travel, and whether you need loops cut into asphalt or concrete. Seniors and veterans get a permanent 10% off, and there’s no trip charge inside the county. Estimates are free. Call (844) 761-9351 for yours.
Why North Las Vegas Homeowners Call Gatewood Fence & Gate North Las Vegas for DoorKing Work
The phone gets answered by a live person, 24/7. No voicemail, no queue three states away. Our team is background-checked and uniformed on every job, and our technicians have up to 25 years of experience, much of it on DoorKing systems. Every job carries the 90-Day Done Right Promise, stated plainly and stamped in writing, not buried in fine print.
We’re a locally owned, owner-operated gate specialist with a published address and license number anyone can look up. The 6050, 6400, and 1520 series are the DoorKings we see most in North Las Vegas, and we know their habits. If it’s LiftMaster, Mighty Mule, or Ghost Controls, we handle those too. If you’ve been burned by a national outfit that quoted one price on the phone and charged another at the door, that’s not how we work.
FAQs
Not if it’s installed per DoorKing’s specs and with approved parts. DoorKing’s warranty covers the operator, not the gate or the install, and improper wiring or wrong safety devices are what typically void it. We install to spec and tell you in writing which parts are OEM and which are quality aftermarket, so there’s no guessing about coverage.
Usually, yes. DoorKing still supports most of the 6050, 6400, and 1520/1530 product lines, though some older control boards are backordered. When that happens, we tell you the real lead time on the genuine part versus a quality aftermarket equivalent, and let you decide. We don’t order anything before you’ve agreed to the price.
Repair it more often than a replacement pitch would suggest. The operator is usually fine; the track, pad, hinge, or wiring is what failed. Our rule is to find the actual cause first. If the control board, motor, or gearbox is genuinely shot and beyond economical repair, we say so plainly, but we don’t sell a replacement when a repair fixes it.
A typical residential DoorKing install is measured within a few days and finished in one to two days on site, assuming parts are in stock or on order. This is a measured, scheduled job, not a same-day emergency call. Call (844) 761-9351 and we’ll give you a realistic window and a written price before anything starts.
Yes. The power run, dedicated circuit if needed, vehicle loops, photo-eyes, and UV-rated safety edges are all part of the install scope. Undersized wire and sun-baked edge rubber are two of the most common failures we fix on DoorKing setups in North Las Vegas, so we size and cap them correctly on the front end. Call for a free estimate.
If your DoorKing gate needs installed or the current setup was never done right, call Gatewood Fence & Gate North Las Vegas at (844) 761-9351 for a free estimate. A live person answers around the clock, the price is agreed before any work starts, and the job carries the 90-Day Done Right Promise in writing. The name is on the shop, and the shop is down the road.
Written by the team at Gatewood Fence & Gate North Las Vegas, serving North Las Vegas and nearby areas.