Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateDoorKing Keypad & Intercom Repair: The North Las Vegas Owner’s Guide
We repair and replace DoorKing keypads and intercoms in North Las Vegas, and most keypad swaps land between $320 and $650 installed, depending on the series and whether the intercom board is involved. Same-day repair is often possible when the part is matched to your model and the low-voltage wiring is sound. Gatewood Fence & Gate is an independent service provider, not affiliated with DoorKing, so when we quote a part we quote what your unit actually needs.
Owners in North Las Vegas usually find out the keypad is failing the same way. The code that worked for years suddenly takes three tries. The talk-back on the intercom goes scratchy or drops out when a visitor presses the call button. The gate opens for a neighbor’s clicker but not for the keypad code. Sometimes the backlight stays dark and the gate just sits there. North Las Vegas sun and dust are hard on exposed entry hardware, and a keypad that lives in direct west-facing sun here ages faster than the same unit under a shaded ramada.
Which DoorKing Models This Applies To
DoorKing keypads and intercoms show up on a wide range of series, from the 1500 and 1800 series keypads to the 1810, 1830 and 1835 entry systems with Talk-Line intercoms. The part has to meet the exact model line. A 1500 series keypad and an 1830 intercom board look similar at the post, but the faceplate footprint, the wire terminal layout and the call programming differ, and the wrong one will not seat in the same cutout.
To identify yours, open the faceplate and read the label inside the housing. The model number, and often the revision letter, is printed there. Measure the faceplate width and the mounting hole spacing if the label is faded. We match on both, because DoorKing changed revision details on some lines and a newer keypad will not always accept an older housing.
On the OEM-or-aftermarket call, it depends on the unit. For an 1830 series intercom where the whole system is original, an OEM board keeps compatibility with the existing handset and door release intact. For a standard 1500 series keypad, a quality aftermarket pad in the same footprint does the same job for less, and we will tell you which way we’d go on your gate. We carry no parts on a truck, so the part gets ordered to your model, not guessed at.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Signs Your DoorKing Keypad & Intercom Repair Is Failing
Here is what we see most often in North Las Vegas, and what each symptom usually means underneath:
- Code takes several attempts. The keypad membrane is wearing through or dust has worked under the contacts. Membranes in full sun fail first, usually after several years of exposure.
- Keypad lights stay dark, gate won’t move. Power is not reaching the pad, or the control board has lost its low-voltage supply. This is a wiring or board issue, not always the keypad itself.
- Talk-back is scratchy or drops out. The intercom speaker, mic or handset line is failing, or a connection at the post has corroded. Wind-driven dust at the post terminals is common here.
- Keypad works, but the gate won’t release on a call. The door-release relay or the intercom board is the culprit. The keypad is fine; the release circuit is not.
- Keypad beeps but rejects every code. The memory has lost its programming, often after a power blink. In many cases it reprogram then works, and you don’t need a new pad at all.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here is the honest range for North Las Vegas, parts and labor together:
| Job | Installed price range |
|---|---|
| Standard DoorKing keypad replacement (1500 series and similar) | $320 – $460 |
| Intercom keypad / entry system replacement (1810, 1830 series) | $480 – $650 |
| Board-level repair or reprogram (no new part needed) | $140 – $260 |
| Add door-release circuit or wiring repair at the post | $90 – $220 additional |
What drives the range: the model line, whether the intercom board is involved, the condition of the low-voltage wiring at the post, and whether the faceplate cutout needs reworking. We quote the price before any work starts, and the price you agree to is the price on the invoice. Every job carries the 90-Day Done Right Promise in writing.
DIY or Call Us?
There is a safe middle ground. You can reset power at the gate operator and let the keypad come back up, check that the post terminals are tight and dry, and confirm your code still works. If the pad comes back after a reset, you may have saved yourself a call.
Where DIY goes wrong: low-voltage keypad and intercom wiring runs back to a live control board, and crossing the wrong pair can take out the operator board along with the keypad. On a DoorKing intercom with a door-release relay on the same circuit, a miswire can leave the gate stuck open or the release locked. That is not a place to guess. The person who shows up here is background-checked and knows the DoorKing terminal map. Call (844) 761-9351 and we will tell you straight whether it’s a keypad or a board.
FAQs
A DoorKing keypad in shaded or covered service commonly runs eight to twelve years. In direct North Las Vegas sun, with our summers and dust, the membrane and keypad face wear faster, and several of the pads we see in North Las Vegas fail closer to six to eight years. A shaded post or a simple sun shield adds years.
Often yes. If the failure is lost programming after a power blink, a bad terminal or a failed intercom relay, we repair it and you keep the original part. If the membrane is worn through or the board is burned, replacement is the right call, and we will show you why before we do it. Call (844) 761-9351 for an exact quote – estimates are free.
A standard keypad swap usually runs one to two hours on site, including reconnecting and confirming programming. An intercom entry system replacement with the door-release circuit takes longer, typically a half day, because we test the release and the call path before we leave. We quote the time window before we start.
We match on the model and revision from the label inside your housing, confirm the faceplate and terminal layout, then order the part to that number. We carry no parts on a truck, and we will not guess at a part that has to fit a cutout. If an aftermarket equivalent in the same footprint saves you money, we will say so. Call (844) 761-9351 for a free second opinion on any written estimate.
Gatewood Fence & Gate is locally owned and owner-operated, and we service nine major gate brands alongside DoorKing, including LiftMaster, Mighty Mule and Ghost Controls. The name is on the shop, and the shop is down the road. The 90-Day Done Right Promise is stamped in writing on every job, and a live person answers the phone around the clock. We are certified to service DoorKing and the other eight brands, and our technicians have up to 25 years of experience. Standing offers include $40 off any repair over $200, no trip charge inside the county, and a permanent 10% discount for seniors and veterans. Call (844) 761-9351 for a free estimate, and you can drive to the shop and look us in the eye.
Written by the team at Gatewood Fence & Gate North Las Vegas, serving North Las Vegas and nearby areas.