Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateElite Keypad & Intercom Repair: The North Las Vegas Owner’s Guide
Elite keypad and intercom repair in North Las Vegas usually runs $185 to $420 installed, depending on whether we’re swapping a keypad, an intercom station, or the wiring between them, and most of that work gets done in a single visit. We’re an independent gate service, not affiliated with Elite, and we work on these units every week. Owners find the failure the same way almost every time: the code that worked Tuesday doesn’t work Friday, or the intercom buzzes but nobody can hear a word. The gate still rolls open from the car remote, so it gets put off. Then a delivery driver can’t get through and it stops being a small problem.
Key Takeaways
- Installed Elite keypad and intercom repair in North Las Vegas runs $185 to $420, quoted before we start.
- We keep the gate running: we compare sticker specs, not eyeball sizes.
- On-site welding and true repair-first. We don’t swap boards that test good.
- Calls answered by a live person, 24/7. The 90-Day Done Right Promise is stamped in writing on every job.
Which Elite Models This Applies To
Elite’s slide gate operators share keypad and intercom platforms across most of the consumer and light-commercial line, so the same EL-series keypad housing often fits several operators, but the control board it talks to does not. That’s the compatibility gotcha that burns people who order the first keypad they find online: an Elite keypad built for the 2000-series board uses a different terminal layout than the newer SL-series boards, and while it will power up and beep, it won’t accept codes. Wrong board, wrong protocol, gate stays shut.
The reliable way to match the part is the model sticker on the operator housing, usually under the cover or on the back panel, plus a photo of the existing keypad terminal block. We don’t eyeball it. On Elite, the OEM route is worth it when the intercom is part of a multi-station system or the keypad shares a board with the gate’s radio receiver. A quality aftermarket keypad is fine for a single-entrance residential driveway, and it saves real money. What we won’t do is sell you a knock-off intercom that won’t pair with your existing station; that just means two trips. Two checkable things worth knowing: Elite’s keypad faceplates take a smaller mounting footprint than LiftMaster’s, so a LiftMaster-style pedestal won’t retrofit cleanly, and the rubber keys on every outdoor keypad in North Las Vegas sun go soft and stop making contact somewhere around the four-to-six-year mark, regardless of brand.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Signs Your Elite Keypad & Intercom Repair Is Failing
Here’s what actually fails first on these units, and the cause behind it.
- The code works sometimes and not others. That’s almost always the keypad contacts, not the board. On an outdoor unit in North Las Vegas, dust and monsoon moisture get behind the faceplate and the membrane stops registering cleanly.
- The intercom buzzes but you can’t hear the visitor. Usually the speaker or microphone in the station, sometimes the wiring jacket cracked from years of UV. Sun-damaged wire on the low-voltage run is common here and easy to miss.
- The keypad lights up but won’t release the gate. The unit is getting power but not sending a valid signal to the operator board. That’s a protocol mismatch or a failed relay inside the keypad, not a dead keypad.
- The gate opens on the remote but never on the keypad. That points at the keypad’s common or relay contact, or the wire run between keypad and operator. The remote uses a different path, so the gate itself is fine.
- Rusted or corroded terminal screws and a keypad that needs two or three presses. Water intrusion at the housing seal. In El Dorado and Aliante we see this on any keypad mounted without a proper drip edge on the post.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s the honest range for North Las Vegas, and the number we quote is the number you’ll see on the invoice.
| What’s involved | Typical installed range |
|---|---|
| Keypad-only swap, single entrance | $185 – $265 |
| Keypad plus new low-voltage wire run | $240 – $340 |
| Intercom station repair or replacement | $280 – $420 |
| Intercom system, multiple stations | $420 – $650 |
What moves the number: whether the wire run needs replacing, whether the operator board needs a new receiver to talk to the keypad, and whether we’re working on one station or a condo-entrance multi-station setup. We do a real diagnosis before we quote, so you’re not paying for a board that tested fine. Labor and parts are shown separately. Every job carries the 90-Day Done Right Promise, stamped in writing; if the code drops out in 60 days, one call brings us back.
DIY or Call Us?
You can safely check a few things yourself. Look at the model sticker on the operator, take a photo of the keypad terminal block, check whether the wire jacket has cracked at the post, and confirm the gate still runs on the remote. That tells us a lot before we arrive.
What you shouldn’t do: open the operator cabinet to test voltage at the control board, or probe the low-voltage wiring with the power on. Gate operator boards and 120-volt feeds live in there together, and the hazard isn’t the gate, it’s the cabinet. Stay out of it. If it’s not the keypad contacts or the wire, it’s a job for someone who knows what’s behind that panel, and we’d rather you call than get hurt. Give us a ring at (844) 761-9351 and describe what happened; we’ll tell you straight whether it’s a keypad, a wire, or a board.
FAQs
A well-sealed outdoor Elite keypad typically lasts four to six years here, and an intercom station five to eight. Heat, UV, and monsoon moisture are what cut that short, so a unit mounted in shade and off a south-facing post lasts longer. Call (844) 761-9351 for a free estimate when yours starts acting up.
Often yes. Keypad contacts, a bad microphone, a cracked wire jacket, or a corroded terminal block can all be repaired on site. We test the component before we pull it, and we repair rather than swap when repair is the right answer. Call (844) 761-9351 for a free estimate.
Most single keypad swaps take 45 minutes to an hour, and an intercom station usually under two hours. If the wire run needs replacing or the operator board needs a matching receiver, expect a longer visit. Call (844) 761-9351 for a free estimate.
By model number from the operator sticker and a photo of the existing terminal block, not a guess. We compare OEM and quality aftermarket options against your board, then quote you the price before any work starts. Call (844) 761-9351 for a free estimate.
We work on Elite every week, along with LiftMaster, Mighty Mule, and Ghost Controls. The name’s on the shop, and the shop is down the road in North Las Vegas. When your gate won’t open for the code, call us at (844) 761-9351 for a free estimate. Live person, 24/7, and upfront pricing every time.
Written by the team at Gatewood Fence & Gate North Las Vegas, serving North Las Vegas and nearby areas.