Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGhost Controls Keypad & Intercom Repair: The North Las Vegas Owner’s Guide
Keypad and intercom repair for Ghost Controls gate systems in North Las Vegas typically runs $185 to $420 installed, and most repairs are handled the same day because failing keypads are usually a power, wiring, or membrane problem rather than a full system failure. We’re an independent gate specialist, not affiliated with Ghost Controls, and we service these units in neighborhoods across North Las Vegas – from the older custom lots near Ann Road to the newer builds out near the Beltway. Most owners find out something’s wrong the same way: the code that worked last Monday suddenly doesn’t, or the intercom goes quiet mid-conversation.
Which Ghost Controls Models This Applies To
Ghost Controls builds its residential openers around a few keypad families – the wireless keypad (model “AXWK” for the AX-series), the “AXCE” series entry keypad, and the “AXIC” intercom kit. Before we order anything, we pull the label on the back of the keypad housing or the control board inside the operator box. If the label’s faded, we match by number of buttons, housing shape, and the wiring connector type – the older 4-wire keypads plug differently from the newer 7-wire units.
Here’s where it gets tricky for North Las Vegas owners: plenty of the systems installed five to eight years ago in this valley’s big master-planned subdivisions run an older pad that Ghost Controls no longer manufactures. The aftermarket has good direct replacements, but there’s a compatibility gotcha – some third-party pads drop the “AX” pairing code entirely, and the opener rejects them on bind. We only use pads that pair with the AX-series board or the correct OEM equivalent.
The OEM-versus-aftermarket decision for a Ghost Controls keypad is real money: an OEM pad runs higher on price, an aftermarket equivalent is often 30-40% less, and the reliability gap on a garage-facing pad in Nevada’s heat is not as wide as people think. We talk through both before ordering.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Signs Your Ghost Controls Keypad & Intercom Repair Is Failing
You’ll usually know by behavior, not by a blinking light. Here’s what we see, and why it happens:
- Code accepted but gate won’t move. The pad is receiving the touch and even beeping, but the signal isn’t reaching the control board – a wiring fault or a failed output relay. That’s a repair, not a swap.
- Pad is completely dead – no beep, no light. Almost always lost power at the pad. In North Las Vegas, sun-baked low-voltage wire in older runs is the most common cause; it’s a $40 to $90 wire fault we find nine times in ten.
- Keys work only sometimes, or the wrong digit registers. Membrane wear inside the pad. On a 6-8 year old pad that’s been in full desert sun, the silicone overlay hardens and shorts a contact.
- Intercom is one-way or crackly. Water in the speaker grille or a corroded speaker lead – the valley’s monsoon season floods these outdoor housings faster than people expect. Sometimes it’s the pad, sometimes it’s just the speaker.
- Pad beeps but the gate reverses and opens again. That’s usually not the keypad at all – it’s a safety-loop or photo-eye issue the keypad is just triggering. We test the whole chain before we charge you for a part.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s an honest range for North Las Vegas, parts and labor:
- Keypad repair (wiring, relay, re-pair): $185 to $320.
- Keypad replacement, OEM or aftermarket pad: $260 to $420 installed, including wiring correction if needed.
- Intercom repair (speaker, cable, connection): $195 to $345.
- Intercom full replacement: $325 to $520.
- Combined keypad + intercom repair: $400 to $650, and we do the whole visit while we’re there.
What drives the range: whether the wire run is intact, whether the pad’s on an older board that limits which models pair, and how complicated the physical install is on an existing post or pillar. Every price is quoted and agreed before we touch anything. $40 off any repair over $200, no trip charge inside the county, free second opinion on any written estimate, and a permanent 10% for seniors and veterans. Every job carries the 90-Day Done Right Promise in writing.
DIY or Call Us?
You can safely check a few things yourself. Pop the keypad off its bracket and look for corrosion or a loose wire. Check the breaker feeding the opener. Power-cycle the control board. If the pad’s got power and a clean wire and still won’t pair, you’ve hit the wall.
Where DIY goes wrong: these low-voltage systems share a board with the opener’s safety photo-eyes and safety loop. If you swap a pad without confirming the board’s pairing mode, you can knock the opener off its safety calibration and the gate will start reversing on close – which is a safety problem, not a convenience one. Keypad and intercom repair of Ghost Controls gear also takes a manufacturer’s wiring map, and the aftermarket pads don’t come with one. Call (844) 761-9351 and I’ll walk you through what’s likely wrong before you buy anything.
FAQs
In North Las Vegas, expect a wireless keypad to run 5 to 8 years, with outdoor intercom units a year or two less because of the heat and occasional monsoon moisture. Anything past seven in full sun on a west-facing post is running on borrowed time.
Yes, and more often than not it can. Wiring faults, output relays, cracked speaker leads, and re-pairing cover most failures, which saves you the part cost. We diagnose first and only replace what’s actually failed – that’s the whole point of the repair-first approach.
Most keypad and intercom repairs run 45 minutes to 2 hours on site. Straight swaps are at the short end; wiring runs to a distant pillar or a board that needs re-pairing push it toward two hours.
We order directly from Ghost Controls or from a vetted aftermarket supplier, and we match the exact part to your label and board before it ships. Most parts land within a few days; a common keypad pad often arrives in 2-3 business days. We don’t carry parts on a truck or stock them locally – we order what fits your gate, then come install it. We also service LiftMaster, Mighty Mule, and DoorKing systems if your setup mixes brands.
Ready to get it fixed? Call (844) 761-9351 for a free estimate – a live person answers any time, day or night. We’ll come out, look at the gate closing on its own or the pad that’s gone dead, quote it upfront, and get your gate working the way it should. The name is on the shop and the shop is down the road – that’s the oldest accountability there is.
Written by the team at Gatewood Fence & Gate North Las Vegas, serving North Las Vegas and nearby areas.