Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateLinear Gate Installation in North Las Vegas: What to Know First
Linear gate installation in North Las Vegas usually runs $2,400 to $6,800 for a driveway or sliding gate with a Linear operator, and most jobs are measured one week and installed the next. We’re an independent Linear service provider, not affiliated with or authorized by the manufacturer, and every price is written down and agreed before a single post goes in the ground. If you own a Linear gate system and want it installed right, call Gatewood Fence & Gate North Las Vegas at (844) 761-9351 for a free estimate.
This page is for owners of Linear equipment – the APeX, the SlideSmart, the SwingSmart, the CSL24 series – who’ve had another company give them a number over the phone and then a different number at the door. We don’t work that way. The estimate you get is the price you pay, in writing, before we start.
Key Takeaways
- Typical Linear gate installation in North Las Vegas: $2,400 to $6,800, quoted upfront and written before work begins.
- We’re independent – not authorized by or affiliated with Linear – so we can use OEM or quality aftermarket parts and tell you honestly which makes sense.
- Installation is measured and scheduled, not same-day. Free measure, written price, then the install date.
- Every install backs the 90-Day Done Right Promise in writing. One call brings us back.
How Linear Products Fail – and How We Fix Them
Linear gear has its own habits. The failures aren’t the same as LiftMaster’s or Mighty Mule’s, and a company that treats all gate operators the same will miss them. Here’s what we actually run into on Linear jobs around North Las Vegas.
- APeX controller network drops after a power flicker. North Las Vegas gets summer brownouts and surge events that knock an APeX access controller offline, and the gate just stops responding to the keypad. We don’t swap the whole board. We check the transformer output, reflash the firmware, and re-pair the controller – then add a surge suppressor on the line so it doesn’t happen again next July.
- SlideSmart drive gear wears before the motor does. On a SlideSmart or CSL24, the nylon drive gear strips long before the motor dies, and you get a gate that moves a few inches and stalls. People get quoted a full operator replacement. What’s actually needed is the gear kit – a fraction of the cost. We pull the cover, inspect the gear, and tell you which it is.
- Battery backs don’t hold on SwingSmart units. The sealed battery in a SwingSmart fades after a few desert summers, and the gate starts stalling or reversing mid-swing. We test the battery under load rather than guessing, then replace only the battery if that’s the fix – not the whole unit.
- Photocell and edge sensor faults from dust and heat. Our dust and heat chew up reflective photo-eyes, and a Linear operator will read a sensor fault as a fault even when the motor’s fine. We clean, realign, or replace the eye, and check the safety edges before we leave.
- Improper loop and wire runs on older installs. Plenty of Linear gates around North Las Vegas were installed by someone who ran the loop wire too close to the operator or skipped the conduit. That shows up as phantom triggering or a gate that opens on its own. We redo the run properly as part of a clean install.
None of this is guesswork. It’s what we see, and it’s why we look before we quote.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Linear Gate Installation Process
Here’s how a Linear installation runs from the first call to the cleanup.
- 1
Phone call, straight to a person. Call (844) 761-9351 and you reach a live person, not a voicemail. We talk through your gate, your operator, and what you want it to do.
- 2
Free measure on site. We measure, check the soil and the slope, look at power and the existing posts, and note the site conditions that matter for a Linear operator – loop placement, sensor sightlines, the power run.
- 3
Parts decision, written out. We give you a written estimate that spells out OEM Linear parts versus quality aftermarket where it makes a difference, and you decide. The estimate doesn’t change at the door.
- 4
Install day. Posts go in, the gate goes up, the Linear operator mounts, and we run the power and the safety edges properly. Hal or the crew is on site for it.
- 5
The test. We cycle the gate with you watching – open, close, obstruction test, safety edge, keypad, remote. You see it work before we call it done.
- 6
Cleanup and the promise. We haul off the debris, walk the job with you, and hand you the 90-Day Done Right Promise in writing. One call brings us back if anything isn’t right.
See the difference
Before
After
Before
After
Before
AfterWhat Linear Gate Installation Costs in North Las Vegas
These are the ranges we see for Linear work around North Las Vegas. Every number is quoted and agreed before work starts – what’s on the estimate is what’s on the invoice.
- Single swing gate with Linear operator: $2,400 – $3,900
- Double swing gate, Linear operators: $4,200 – $6,800
- Sliding gate with SlideSmart or CSL24: $3,100 – $5,400
- Pedestrian gate with Linear operator: $1,800 – $2,900
- Operator replacement only (gate stays): $1,100 – $1,900
- Access control / keypad / loop added: $450 – $1,200
What moves the price: gate width and weight, whether power has to be run to the site, slope, soil, and whether you want access control. Averages are averages – a wide double gate with a long power run sits at the top of the range. Call (844) 761-9351 and we’ll set up a free measure. You’ll get a written price, no haggling required, no trip charge inside the county, and a permanent 10% discount for seniors and veterans.
Why North Las Vegas Homeowners Call Gatewood Fence & Gate North Las Vegas for Linear Work
The name is on the shop and the shop is down the road. Gatewood Fence & Gate North Las Vegas has been locally owned and owner-operated since 2001, and our technicians have up to 25 years of experience working on Linear and the other eight major brands we service. We’re certified across nine brands – LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule – so if your Linear operator ever needs to be swapped or matched, we can speak to every option honestly.
Every job carries the 90-Day Done Right Promise in writing, and one call brings us back. Calls reach a live person 24/7, not a voicemail or a call center three states away. And you get no-hassle upfront pricing with standing offers that don’t require haggling: $40 off any repair over $200, no trip charge inside the county, a free second opinion on any written estimate, and a permanent 10% discount for seniors and veterans. The face you see at the estimate is the face at the install.
FAQs
An installation done correctly by a qualified installer doesn’t void a Linear manufacturer warranty, but sloppy wiring, wrong gauges, or unapproved parts can. As an independent Linear service provider we follow Linear’s installation spec – the right wire, the right loop placement, the safety edges in the right spots – so the warranty stays intact. Call (844) 761-9351 to talk through your situation.
Yes. Linear parts are widely available through distribution, and for the APeX, SlideSmart, SwingSmart, and CSL24 series we use OEM or quality aftermarket depending on the job – and we tell you which and why in the written estimate. Call (844) 761-9351 for a free estimate.
Often repair. A stripped SlideSmart drive gear or a dead SwingSmart battery is a repair, not a replacement, and we’ll say so. We only recommend replacing when the board is gone or the motor itself has failed. A free second opinion on any written estimate you already have is one of our standing offers – call (844) 761-9351.
Installation is a measured, scheduled job, not same-day service. We measure within about a week typically, then schedule the install once the parts are in hand and the estimate is agreed. Call (844) 761-9351 and we’ll give you a real date, not a maybe.
Yes. The power run, the loop wire, the photocells, and the safety edges are part of a proper Linear installation, and we handle all of it – running conduit, setting the loop away from the operator, and testing the edges before we leave. Call (844) 761-9351 for a free estimate.
Written by the team at Gatewood Fence & Gate North Las Vegas, serving North Las Vegas and nearby areas.