Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateViking Gate Motor & Opener in North Las Vegas: What to Know First
We repair, replace and service Viking gate motors and openers in North Las Vegas as an independent Viking service provider, and most of the Viking calls we run here get a diagnosis the same day and a working gate within one or two visits, depending on parts. You’ll get an upfront price before we touch anything, and it doesn’t change at the door. This page is for Viking owners in North Las Vegas – the ones with a Viking gate operator on a driveway gate and a remote that’s stopped doing what it used to. If that’s you, call (844) 761-9351 and a live person answers, day or night.
How Viking Products Fail – and How We Fix Them
Viking builds solid operators, and most of the failures we see in North Las Vegas aren’t the brand’s fault – they’re wear, heat and the way the gate itself has drifted over the years. Here’s what actually shows up on our Viking jobs.
- Control board corrosion on the K-series and L-series swing operators. North Las Vegas dust and the occasional monsoon-season humidity work their way into the enclosure, and the low-voltage board starts acting up before the motor ever does. You’ll see a remote that works only up close, or a gate that opens partway and reverses. We test the board before condemning anything, because a board that reads fine on the meter often just needs the terminal connections cleaned and reseated.
- Battery backup that quits after two summers. Viking’s battery-backup models run on sealed lead-acid batteries, and Southern Nevada heat eats them faster than Viking’s literature suggests. A gate that won’t move when the power blinks is usually telling you the battery is done, not the operator. We load-test the battery on the spot and replace it, rather than selling an operator you don’t need.
- Limit and torque settings that drift on slide operators. On Viking slide gate operators, the limit switches and torque settings move out of adjustment as the gate settles and the track wears. The symptom looks like a motor failure – the gate stops short or reverses – but the fix is adjustment, not replacement. We set the limits to the gate as it actually sits today, not to the manual’s factory numbers.
- Intercom and entry wiring on the add-on kits. Viking’s intercom and keypad integration runs low-voltage, and in North Las Vegas we regularly find moisture in the outdoor junction boxes and splices that were never meant to see weather. The gate works, but the intercom is dead or the keypad won’t wake up. We trace the run, redo the splices properly, and seal the boxes.
- Motor brushes and gear wear on older units. The older Viking motors that are still going strong here – some of them well over a decade of service – eventually wear brushes and gears. That’s a rebuild or a replacement call, and we tell you which one honestly. If a quality aftermarket brush set gets you five more years, that’s what we’ll recommend, and it won’t void anything on a Viking unit that’s out of warranty anyway.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Viking Gate Motor & Opener Process
From the first call to the last sweep of the driveway, here’s how a Viking job runs with us.
- 1
You call and talk to a person. No voicemail, no queue. We ask what the gate is doing and what kind of Viking operator you have, and we set a window you can count on.
- 2
We test the whole gate, not just the box. The operator is one part of the system. We check the gate’s swing or slide, the hinges and track, the wiring, the battery and the board before we decide anything. A gate sags in the hinge post, not in the middle, and that’s where we start.
- 3
We give you the price before the work. Upfront, in writing, no surprises. If a repair gets you years of service, we fix it. If it doesn’t, we tell you why – but we don’t swap parts that don’t need swapping.
- 4
Parts decision: OEM vs. quality aftermarket. On a Viking unit still under warranty, we stay with OEM parts to protect it. On older units, quality aftermarket boards, batteries and brush sets are often the smarter money, and we’ll say so.
- 5
We do the repair and test it under load. Every repair gets run through full open-close cycles with the safety edges and reversing tested. If it doesn’t pass, it isn’t done.
- 6
We clean up and back the work for 90 days. The 90-Day Done Right Promise is stamped in writing on the job. If it’s not right, one call brings us back.
See the difference
Before
After
Before
After
Before
AfterWhat Viking Gate Motor & Opener Costs in North Las Vegas
Every Viking job is quoted and agreed before any work starts, so the price you hear is the price you pay. Here are the ranges we see for common Viking scenarios in this market.
| Job | Typical range |
|---|---|
| Diagnostic visit (no trip charge inside the county) | $0 – credited toward the repair |
| Battery backup replacement | $180 – $320 |
| Control board repair or replacement | $280 – $650 |
| Limit and torque adjustment, wiring repair | $150 – $300 |
| Motor brush or gear rebuild | $250 – $500 |
| Full Viking operator replacement | $950 – $1,900 |
What moves the price: which Viking operator you have, whether the board is repairable or has to be replaced, OEM versus quality aftermarket parts, and how much of the wiring and gate hardware needs attention along with the operator. If you’ve got a written estimate from another company, we’ll give you a free second opinion on it. Estimates are free, and there’s $40 off any repair over $200.
Why North Las Vegas Homeowners Call Gatewood Fence & Gate North Las Vegas for Viking Work
We’re locally owned and owner-operated, and the name is on the shop and on every invoice. You can look up the address and the license number yourself – that’s the oldest accountability there is. Every job carries the 90-Day Done Right Promise in writing, not buried in fine print.
Our technicians have up to 25 years of experience, and we’re certified on nine major gate brands, so when a Viking operator turns out to be something else, we don’t walk away. We work on LiftMaster, Mighty Mule, Ghost Controls, DoorKing and the rest, which means you get a straight answer about the operator you actually have, not the one we’d rather sell you. Calls are answered by a live person 24/7. If it’s a repair over $200, take the $40 off. Seniors and veterans get a permanent 10% discount. No haggling required.
FAQs
No – not when the repair is done correctly with the right parts. On a Viking unit still under warranty, we stay with OEM parts so nothing gets compromised. On older units out of warranty, quality aftermarket parts are fine and often save you money. We’ll tell you which side of that line you’re on before any work starts. Call (844) 761-9351 for an exact quote – estimates are free.
That usually points to the low-voltage access wiring, not the operator. In North Las Vegas we regularly find moisture in the outdoor junction boxes and splices that weren’t sealed properly, killing the keypad or intercom while the gate itself keeps running. We trace the run, redo the connections and seal the boxes. Call (844) 761-9351 and we’ll take a look.
We source both OEM and quality aftermarket Viking parts, and most common items – batteries, boards, brushes, remotes – are available quickly. Less common parts may take a few days. We’ll tell you the timeline before you commit, and there’s no trip charge inside the county. Call (844) 761-9351 for a free estimate.
Usually not. On Viking operators, a gate that reverses partway is more often a limit or torque setting that’s drifted, a safety edge that’s failed, or a gate that’s dragging on its track or hinges. We test the whole system before we condemn the motor – that’s the difference between a repair and a replacement. Call (844) 761-9351 for an exact quote.
Most Viking repair calls in North Las Vegas get a same-day or next-day visit, depending on parts. When you call, we set a window you can count on and a live person answers 24/7. Estimates are free, so call (844) 761-9351 today.
Call (844) 761-9351 for a free estimate on your Viking gate motor or opener in North Las Vegas. A live person answers, day or night. We’ll quote it upfront, agree on it before any work starts, and back it with the 90-Day Done Right Promise in writing.
Written by the team at Gatewood Fence & Gate North Las Vegas, serving North Las Vegas and nearby areas.